MGP WRM2 Spezifikationen PDF herunterladen (Seite 24)

15-00044

Revision 5

April 2008

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 24

The Interval time level is based on how long a unit can run without AC power, 99 seconds is the maximum

transmission time interval.

To check if the DRM is in Power Saving Mode press on the ‘GET BUTTON’ in the “Setup Device” window in

the RMV software and the background window will be display ‘8888’ to signify that the DRM is in the Power

Saving Mode.

4.2.10 Dose Rate Alarm Threshold Settings

Dose threshold settings are configured via the RMV software (Version 4.01 and DRM firmware ). The Def.

hreshold (thr.0) is the current default setting in the DRM, i.e. Threshold (1) one is the current default dose rate

threshold (see figure below), thr.0. To change the threshold setting using the ACK button on the display, toggle

to the desired Threshold number, i.e. thr.3, let go of the ACK button and the display will show the stored

threshold setting and will be defaulted to this rate threshold alarm setting.

Example of the Setup Device Window for with the Dose Rate Threshold Settings

4.2.11 Dose Function

Dose reading can be read as a part of the data record sent by the DRM.

To enable this function:

1) Connect the DRM to the PC and run RMV software

2) Move dipswitch 1&2 to the ON position, and set DOSE enable in the RMV software

If the DOSE reading is disabled, in place of a real dose reading, the record will be shown as 888888.8. The Dose

reading will be reset to zero in two cases: Disable\Enable Dose function, turn the DRM On. Each time the

instrument is turned ON; the Dose reading is reset to zero.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

Keine Kommentare

MGP WRM2 Spezifikationen Seite 24