MGP WRM2 Spezifikationen PDF herunterladen (Seite 47)

15-00044

Revision 5

April 2008

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 47

11. Upgrading the DRM firmware

Note: Follow these directions carefully (contact MGPI for assistance)

1. Install the DRM Firmware Updater software by unzipping the files to a known directory and clicking on the

‘Setup’ in the ‘Installer’ directory.

2. Disconnect the meter from the power supply and ensure that the battery back-up is also turned OFF

; dip

switches 1 and 2 in the OFF position, see figure 2 or 3

3. Set dipswitch 1& 2 to on position

4. Set dipswitch 3 to 8 to off position

5. Open the back meter panel, see figure 2 or 3

6. Switch E1 located at mother board card to update position (upward). See Figure2 for the DRM-1 or Figure

3 DRM-1D

7. Connect the meter to the PC via the RS-232 cable and NULL modem adapter.

8. To start the Firmware Updater software double clicking the ‘Application.exe’ icon in the

known directory.(see next page for screen view)

9. Set the PC Communications Port and load the supplied *.hex file,, i.e. “drm1-4769.hex” located in the

known created directory for the software.

10. Select "send an answer " function 1 (Check)

11. Click on the Start (white arrow) to initialize the program.

12. Connect the meter to the power supply information should appear in the File Read screen.

13. If the menu does not appear, turn (disconnect) the power supply off, click on the stop (red point) icon and

go back to item 10

14. Click on the "send 1" button

15. Check that the right hand window displays “Enter to command > 1 **** Ready to receive

16. Click on "send 2"

17. Check that the right hand window displays “The file was verified and is good for update” Enter

command

18. Select "send an answer " function 2 (Update)

19. Click on "send 1"

20. Check that the right hand window displays “Enter to command > 2 **** Ready to Receive

21. Click on "send 2" wait…

22. Check that the right hand window displays “Firmware update complete” and verify that the information

in the window is exactly like figure 1 before removing the AC power

23. Disconnect the power supply and remove the serial/null cable.

24. Switch E1 located on the motherboard card 2143 to inverse "update" position (downward).

25. Connect the power supply and verify that the meter operates.

26. Ensure Dip Switches 1, 2, and 3 are in the ON position.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 61 62

Keine Kommentare

MGP WRM2 Spezifikationen Seite 47