MGP WRM2 Bedienungsanleitung PDF herunterladen (Seite 10)

15-00043

Revision 3

September 2005

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 10

The PAM-TRX has been designed to drive an external LED or high impedance Earphone that

follows the alarm signal. The stereo alarm connector is compatible with MGPI external alarm

devices like the EAM and the PEA-100 in the event that the user desires to use the PAM-TRX as a

wireless area-monitoring device or further enhance the volume of the audio signal to over 100 dBA.

NOTE: USE ONLY THE EARPHONE PROVIDED BY MGPI OR EQUIVALENT.

STANDARD 8 OHM EARPHONES WILL NOT OPERATE.

2.1.5 Operational Test

2.1.5.1 Make sure that a fresh ‘AA’ alkaline battery has been installed and that the PAM-TRX is

powered.

2.1.5.2. Verify that the internal dipswitch settings are correct.

2.1.5.3 Verify that the dosimeter is installed, turned ON and operational. The low battery alarm

circuit may be energized for a few seconds while the battery test circuit charges up,

depending upon how long the power has been off.

2.1.5.4 Press the Test button to verify that the alarm functions are activated. When the Test

button is released, all alarms should be deactivated.

2.1.5.5 Ensure the green LED flashes every 4 seconds (or as configured) and that the base units

registers the data received and displays the correct dosimeter number and readings on the

monitoring software.

2.1.6 Usage

Perform an operational test before installing the unit.

CAUTION: Do NOT use the PAM-TRX if it fails the operational test!

The PAM-TRX is designed for pocket use, in a visible location as close as practical to the TLD

badge. Follow HP/RP recommendations/requirements for body placement.

CAUTION: The vibration alarm feature is only effective if the PAM-TRX unit is in

contact with the body.

2.1.7 Battery Replacement

The battery used is 1.5 VDC ‘AA’ Duracell or Energizer brand alkaline.

2.1.7.1 Remove the battery cover, battery and case back cover.

2.1.7.2 Properly dispose of battery.

2.1.7.3 Install a new battery, ensuring correct polarity position (refer to Figure 2).

2.1.7.4 Close the cover and tighten the locking screw. Be cautious not to

overtighten the locking screw.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Keine Kommentare

MGP WRM2 Bedienungsanleitung Seite 10