MGP WRM2 Bedienungsanleitung PDF herunterladen (Seite 15)

15-00043

Revision 3

September 2005

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 15

In Position 3, the RS-232 serial connector Rx and Tx lines are connected to the network adaptor

RS-232 serial lines. To configure the network adapter, Windows HyperTerminal is the preferred

method and is described in this section. (Refer to Appendix 2 for alternate programming software

method)

To program the network adapter:

1. Power ON the WRM2 Base unit.

2. Set the Rotary Mode Selector to Position 3.

3. Connect a straight RS-232 (9-pin Serial Cable) to the DB-9 connector of the Base unit and PC

4. Run Windows HyperTerminal (typically located in Start, Programs, Accessories,

Communications of the windows desktop). The following window appears (Figure 6 below):

Figure 6: New Connection

5. The Connection Description window opens. Provide a Name and click OK

6. The Connect To window will then be displayed (Figure 7 below)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

MGP WRM2 Bedienungsanleitung Seite 15