MGP WRM2 Spezifikationen PDF herunterladen (Seite 48)

TelePole WR/ Operating & Maintenance Manual Page 48

9.3. Detector disassembly (14)

9.3.1. Loosen the three NC 4-40x3/8 Philips flat screws located at the bottom of the detector

(14).

9.3.2. Gently pull the detector (14) about two cm out with one hand. Hold the detector cable

with the other hand and continue drawing the detector tube out until the connector is

visible. Press the connector's plastic clip to disconnect the cable from the detector. Hold the

cable end with a clip to prevent it from entering back into the pole.

9.3.3.

Figure 7-2. Detector disassembly

9.4. Meter disassembly (4, 5)

9.4.1. Disconnect the detector phone cable connector from the meter rear panel by pressing the

plastic clip.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 57 58

Keine Kommentare

MGP WRM2 Spezifikationen Seite 48